Arduino - BT module

Damn....I bought y couple of HM-10 on ebay....or better say CC41-A.
If you enter AT+VERSION you'll get something like:
+VERSION=Firmware V3.0.6,Bluetooth V4.0 LE

If you tra AT+HELP you'll get:

********************************************************************
* Command             Description                    *
* ---------------------------------------------------------------- *
* AT                  Check if the command terminal work normally  *
* AT+RESET            Software reboot               *
* AT+VERSION          Get firmware, bluetooth, HCI and LMP version *
* AT+HELP             List all the commands                 *
* AT+NAME             Get/Set local device name                    *
* AT+PIN              Get/Set pin code for pairing                 *
* AT+PASS             Get/Set pin code for pairing                 *
* AT+BAUD             Get/Set baud rate                         *
* AT+LADDR            Get local bluetooth address         *
* AT+ADDR             Get local bluetooth address         *
* AT+DEFAULT          Restore factory default            *
* AT+RENEW            Restore factory default            *
* AT+STATE            Get current state               *
* AT+PWRM             Get/Set power on mode(low power)          *
* AT+POWE             Get/Set RF transmit power          *
* AT+SLEEP            Sleep mode                          *
* AT+ROLE             Get/Set current role.                      *
* AT+PARI             Get/Set UART parity bit.                     *
* AT+STOP             Get/Set UART stop bit.                       *
* AT+START            System start working.            *
* AT+IMME             System wait for command when power on.      *
* AT+IBEA             Switch iBeacon mode.                      *
* AT+IBE0             Set iBeacon UUID 0.                          *
* AT+IBE1             Set iBeacon UUID 1.                          *
* AT+IBE2             Set iBeacon UUID 2.                          *
* AT+IBE3             Set iBeacon UUID 3.                          *
* AT+MARJ             Set iBeacon MARJ .                          *
* AT+MINO             Set iBeacon MINO .                          *
* AT+MEA              Set iBeacon MEA .                          *
* AT+NOTI             Notify connection event .                    *
* AT+UUID             Get/Set system SERVER_UUID .                  *
* AT+CHAR             Get/Set system CHAR_UUID .                  *
* -----------------------------------------------------------------*
* Note: (M) = The command support slave mode only.          *
* For more information, please visit http://www.bolutek.com        *
* Copyright@2013 www.bolutek.com. All rights reserved.         *
********************************************************************

Bolutek sells CC41-A, not HM-10.
And on an CC41-a 'at+help' will work the same way as 'AT+HELP', while HM-10 should be casesensitive.
Is there a chance to use the HM-10 firmware anyway?